Do not click this button here. Leave the copier at room temperature for at least 2 hours before use. Used to set transmission end sound tone in transmission. Interrupting operation check Returns to the upper hierarchy. Disassembly procedure 1 Remove the paper holding arm. Remove the TD cartridge and close the front cover and side cover, in that order. When the electrical resistance is reduced, positive charges on the aluminum layer are moved and neutralized with negative charges on the OPC layer.

Uploader: Voodoosho
Date Added: 11 November 2015
File Size: 15.26 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 44891
Price: Free* [*Free Regsitration Required]

Sharp FO-DC Parts List and Diagrams

Set content After 2sec, main code and sub code input display. When the mirror base unit returns to the home position, the acquired value is displayed.

Attach the FCC to fit with the marking line. Not error reception Inhibited to use V. When the electrical resistance is reduced, positive charges on the aluminum layer are moved and neutralized with negative charges on the OPC layer.

The paper information is cleared for every copy.

In this case, laser discharge is required when stopping the motor, the polygon motor is also operated at the same time. Necessary tool for copy density adjustment 2 Perform the adjustment in each mode. Set range Mute judgment time Binary input Bit No. Normally the correct language is selected automatically. That is, it covers the adjustment of the second surface printing mode image loss at the front edge of an image in which image data is once stored in memory.


SPF motor 1 Remove the harness. Void position to be check There are two adjustment modes: When the set value is decreased, copy becomes lighter. Entering the test command mode To enter the serviceman test command mode, press the to as follows: The indicator blinks when the tray Press this key to select the paper size for copying, to configure a is out of paper during operation or is not closed properly.

Inhibit Auto receive select in answering telephone connection mode Inhibited to use 1: Enter the adjustment value with [10KEY]. Since it is performed by changing the scan end position, the image position adjustment is made by dc55 the scan end position and the end data stored in memory.

Paper feed section and paper transport section. When the set value is increased by 1, the void amount is increased by about 0.

Copy density adjustment Paper rear edge A. When a mm scale is used as the original. However, warm-up is continued.


Sharp FO-DC Drivers Download – Update Sharp Software

Disassembly procedure Multi unit 1 Remove the screw and remove the multi upper cover. Looking for a tech bargain real soon? At that time, the manual paper feed roller is rotating. When the settings have been completed, click the “OK” button to close the screen.

Sharp FO DC550 Supplies

Yes Initial value Inhibited to use 7 8 1 2 3 Switch selection and contents of functions 0 0 0 Bit No. As a Gold Go Independent Software Vendor ISVSolvusoft is able to provide the highest level of customer satisfaction through delivering top-level software and service solutions, which have been subject to a rigourous and continually-audited approval process by Microsoft.

Also, press this key to insert a pause when entering numbers.

Detection level in busy tone detection. As the photoconductor is charged by the saw tooth from the main corona unit, the surface potential increases. Copy density adjustment timing The copy density adjustment must be performed in the following cases: In one send job, the send document size is fixed.